Auger Anchor

Safely anchor your jetskis, boats and pontoons with Auger Anchor

How to use your Auger Anchor boat anchor to safely anchor your jetski, boat or pontoon

Installation Instructions

To install the AUGER ANCHOR BOAT AUGER in the water:

  1. Insert the handle inside the top cover and rotate 1/4 turn until the handle drops over the shaft.
  2. Wrap the rope around the top of the T-handle to secure the handle and the auger together.
  3. Wade out into the water to 3 to 5 foot depth, firmly plant the nose of the auger into the ground and with downward pressure rotate the handle clockwise until both blades are fully submerged so the rope and the eye bolt are at ground level approximately 18 inches deep.
  4. Unwrap the rope from around the top of the T-handle and attach the carabiner to the watercraft.
  5. Remove the handle.
  6. Your watercraft is now secured.

While your watercraft is in use the float will keep the end of the rope with the carabiner on top of the water to mark your spot and to locate the auger.

For larger boats an extension rope might be needed with a drag anchor over the opposite end of the boat to keep it from drifting around.

To Remove the Auger:

  1. Take the handle out to the float.
  2. Unhook the rope from the watercraft.
  3. Follow the rope down to locate the auger cover.
  4. Insert the handle inside the top cover and rotate 1/4 turn until the handle drops over the shaft.
  5. Wrap the rope around the top of the T-handle to secure the handle and the auger together.
  6. Rotate the handle counter clockwise until the auger is free from the ground.

Follow the same instructions out of the water for use on land.

To store the handle remove cross tube from T-handle and insert into the shaft from the top, line up the pin holes and insert the locking pin to secure the cross tube inside the handle shaft.

Auger anchor mini anchor
Installation Instructions

To install AUGER ANCHOR MINI AUGER as a doggie auger, RV awning, tent, etc.:

  1. Remove eye bolt from end of auger.
  2. Insert flat end of auger shaft into auger handle.
  3. Firmly plant the nose of the auger into the ground and with downward pressure rotate the handle clockwise until the top of the auger is approximately 1 1/2 inches below ground level.
  4. Thread the eye bolt into the top of the auger and tighten using the cross bar on the handle (just stick the end of the cross bar into the eye bolt hole and turn).
  5. Only the top half of the eye bolt should be sticking up above ground level. (cover with dirt if needed).
  6. Attach the leash, cable or rope to the top of the eye bolt.

To install AUGER ANCHOR MINI AUGER to anchor a structure like a canopy or green house:

  1. Remove eye bolt from end of auger.
  2. Insert flat end of auger shaft into auger handle.
  3. Firmly plant the nose of the auger into the ground and with downward pressure rotate the handle clockwise until the top of the auger is flush ground level (if the legs on your structure are angled install the auger at approximately the same angle as the leg).
  4. Set the structure on top of the auger and line up the hole on the structure with the threaded hole on the auger and thread the eye bolt into the auger and tighten using the cross bar on the handle (just stick the end of the cross bar into the eye bolt hole and turn).